10
Maintenance
Cleaning
The elliptical trainer can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the elliptical
trainer after each use. Be careful to not get excessive moisture on the computer display
panel as this might cause an electrical hazard or electronics to fail. Please keep the
elliptical trainer, especially the computer console out of direct sunlight to prevent screen
damage. Please inspect all assembly bolts and pedals on the machine for proper
tightness every week.
Storage
Store the elliptical trainer in a clean and dry environment away from children.
Maintenance and Adjustment
Optional Power Supply
Your Elliptical Trainer uses a generator to operate the
computer and resistance mechanism. The computer
uses a rechargeable battery to maintain power if the
user were to stop or drop below the minimum rpm’s
needed for the computer to operate properly. If you
haven’t used your elliptical trainer for a long period of
time, the battery can go dead. You can recharge it by
simply working out or it can also be charged using an
optional power supply. Please contact Bodycraft for
additional information.
Optional
Power
Supply
Leveling
There are 6 LEVELERS that prevent the elliptical trainer from wobbling or shaking during exercise.
Follow these steps to level your machine.
1. Start by threading in the middle 2 LEVELERS completely into the frame.
2 Adjust the 4 OUTER LEVELERS [C05] on the MAIN FRAME [A01] and GUIDE RAIL [A12] as
needed to stabilize the elliptical trainer.
3 Adjust the 2 MIDDLE LEVELERS until they touch the floor.
4. 5
Test for stability. If satisfied, tighten each of the 6 Jam Nuts up into the frame (located on each of
the levelers) to lock your adjustments.
OUTER
LEVELERS
OUTER
LEVELERS
MIDDLE
LEVELERS
BOTTOM VIEW
Summary of Contents for ECT400g
Page 1: ...ECT400g Elliptical Cross Trainer ...
Page 27: ...Memo ...
