15
STEP 8 INSTALL CABLE ARM CABLE
P1
P2
P5
P4
P6
P3
P7
P9
P8
P7
26
109
145
76
17
15
P5
76
124
122
23
P1,P2,P3
P1
P2
P3
26
76
17
15
145
109
P4,P6
26
26
145
137
76
107
137
76
17
P3
P6
P4
CABLE ARM CABLE (69)
17
P8,P9
P8
P9
1. The Cable Arm Cable (69) is already run through the Cable Arm (15). Mount Pulley P3 and
P7 along with their Pulley Guide Brackets (26) to the Cable Arm Assembly (17) as shown,
using one 3/8" X 1-3/4" Hex Bolt (109) and one 3/8" Nylon Nut (145). Route the cable over
top of these pulleys. Tighten these nuts, making sure the Pulley Guide Brackets (26) do not
rub against the cable.
2. Continue routing, on both sides, down and around pulleys P4 and P6 mounted to the base
of the Cable Arm Assembly (17) using one Pulley Guide Bracket (26), one 3/8" X 5-3/4" Hex
Bolt (107), and one 3/8" Nylon Nut (145) for each side. Tighten these nuts, making sure the
Pulley Guide Brackets (26) do not rub against the cable.
3. Route the cable up to pulley P5 mounted inside the Adj Floating Pulley
Block (23) that is dangling at the end of the Connect Cable (69). Install
pulley using one 3/8" X
30.5L Flat Pin Bolt (122)
and one M6 X 12L Male
Screw (124).
Ball End
Ball End
