60
60
60
60
60
60
60
60
51
35
43
50
50
38
38
61
61
107
107
96
96
78
97
62
62
40
40
40
40
40
40
40
40
107
LAT BAR
1.Insert three Foam Roller Bars (30) into holes in Leg Extension (32) and Leg Extension Adjuster
(31). Wet Foam Roller Pads (40) and slide onto Foam Roller Bars (30). Insert 1" ID round End
Plugs (60) onto each end of Foam Roller Bars (30). A rubber mallet is the best tool.
2.Slide Seat Hinges (26) onto axle on Seat Slider (25) as shown. Attach Seat Pad (44) to Seat
Hinges (26), using two 3/8” Washers (107) and two 3/8” X 1” Hex Bolts (97).
3.Attach Back Support (27) to welded tabs on Seat Slider (25), using two 1/2" Bushings (70), one
1/2" x 4" Hex Bolt (84) and one 1/2" Nylon Nut (111). Attach two Back Support Braces (28) to
Bench Main Frame (24) and Back Support (27), using one 1/2" x 4-1/4" Bolt (83), four 1/2"
Washers (106) and one 1/2" Nylon nut (111). All three bolts in this step should be tightened,
then backed off just enough to allow free rotation.
4.Attach Back Pad (45) to Back Support (27), using two 3/8" Washers (107) and two 3/8" x 2-1/2"
all threaded Bolts (96).
5.Insert last Foam Roller Bar (30) into holes in Adj. Knee Holder (20). Wet inside of two Foam
Roller Pads (40) and slide onto Foam Roller Bar (30). Cap Foam Roller Bar (30) with 1" End
Plugs (60).
Tighten all bolts.
STEP 4 Bench Assembly
Ⅱ
-8-
