18
STEP 11 INSTALL CABLE ARM CABLE
P1
P2
P3
P4
P7
P8
P9
P5
P6
P7
100
170
134
27
18
16
P1,P2,P3
P1
P2
P3
27
18
100
134
170
16
P4,P6
27
27
100
170
163
100
132
163
18
P3
P6
P4
CABLE ARM CABLE (86)
18
P8,P9
P8
P9
Ball End
Ball End
85
26
24
101
145
147
P5
1. The Cable Arm Cable (86) is already run through the Cable Arm (16). Mount pulleys P3 and P7
along with their Pulley Guide Bracket (27) to the Cable Arm Assembly (18) as shown, using one 3/8"
X 1-3/4" Hex Bolt (134) and one 3/8" Nylon Nut (170). Route cable over top of these pulleys.
Tighten these nuts, make sure the Pulley Guide Brackets (27) do not rub against the cable.
2. Continue routing, on both sides, down and around the pulleys P4 and P6 mounted to the base of
Cable Arm Assembly (18) using one Pulley Guide Bracket (27), one 3/8" X 5-3/4" Hex Bolt (132), two
3/8" Washers (163) and one 3/8" Nylon Nut (170) for each side. Tighten these nuts, making sure the
Pulley Guide Bracket (27) do not rub against the cable.
3. Route the cable up to pulley P5 mounted inside the Single Pulley Block (24) that is dangling at the
end of the Connect Cable (69). Install pulley using one 3/8" X 33.5L Flat Pin Bolt (145), one Cable
Guide Plate (26) downward and one M6 X 12L Male Screw (147).