7
STEP 2 TOP FRAME AND WEIGHT STACK ASSEMBLY
156
173
161
161
110
161
169
169
109
75
59
57
6
3
2
1
110
180
58
93
93
4
130
180
180
163
163
161
130
1. Attach the two Guide Rods (6) to
the weight stack plate welded to
the Rear Stabilizer (2) using two
3/8" X 3/4" Hex Threaded Bolts
(180).
2. Slide one Rubber Cushion (110)
onto each Guide Rod (6). Then
slide each 10 Lbs. Weight Plate
(59) onto the Guide Rods (6),
making sure the selector holes
are oriented toward the side and
bottom.
3. Attach Top Plate (58) to the
Selector Rod (57) using Top Plate
Bolt (156). Tighten Top Plate Bolt
(156) using a Hex Wrench. Slide
the Top Plate (58) onto the Guide
Rod (6), running the Selector Pin
(75) down through the center holes
of the Weight Plates (59).
4. Insert the two 1" ID Guide Rod
Holder (109) into the holes in the
Top Frame (4). Place Top Frame
(4) on the top of the Front Upright
(3) and Guide Rods (6). Make sure
the Guide Rods (6) are inserted
into the 1" ID Guide Rods Holders
(109).
5. Secure the Top Frame (4) to the
Front Upright (3) using two 1/2" X
3-1/4" Hex Bolts (130), four 1/2"
Smaller Washers (161), and two
1/2" Nylon Nuts (169). Secure the
Top Frame (4) to the Guide Rods
(6)) using two 3/8" X 3/4" Hex
Threaded Bolts (180).
and two 3/8" Washers
(163).
