STEP 1 MAIN FRAME ASSEMBLE
5
46
46
46
46
62
62
74
74
74
74
74
74
61
59
73
73
73
76
76
74
74
74
74
77
77
77
77
77
77
74
74
50
50
61
74
65
74
77
50
50
42
42
48
23
61
74
74
65
74
19
27
27
42A
42A
69
40
18
17
37
37
48
47
47
8
1
3
5
7
2
4
To ease the assembly process, do not tighten bolts until instructed.
1.Attach the Rear Stabilizer (2) to the Base Frame (1) using two 3/8" X 3-1/8" Hex Bolts (61), four 3/8"
washers (74) and two 3/8" Nuts (77).
2.Attach the Front Stabilizer (8) to the Base Frame (1) using two 3/8" X 3-1/8" Hex Bolts (61), four
3/8" washers (74) and two 3/8" Nuts (77). Slide four 50mm SQ. End Caps (46) onto the Rear
Stabilizer (2) and the Front Stabilizer (8).
3.Attach the Low Row Foot Plate (4) to the Base Frame (1) using two 1/2" X 3-1/8" Hex Bolts (59),
four 1/2" Washers (73) and two 1/2" Nuts (76). Insert two 50mm X 75mm End Caps (47) into each
end of the Low Row Foot Plate (4).
4.Attach the Upright (3) to the Base Frame (1) using four 3/8" X 3" Hex Bolts (62), eight 3/8" Washers
(74), and four 3/8" Nuts (77).
5.Insert two Guide Rod Holders (50) into the Rear Stabilizer (2). Slide a 2" Rubber Donut (42) onto
the end of each Guide Rod (5). Insert the Guide Rods (5) with Rubber Donuts (42) into the Guide
Rod Holders (50) in the Rear Stabilizer (2).
6.If you did not purchase optional weight stack, please skip this step. Slide each 10 lb. Plate (18)
over the Guide rods (5). Make certain that each plate is oriented with the selector hole on bottom
and facing forward. Attach Two Way Top Plate (17) to the Selector Rod (19) using the Top Plate Bolt
(69).
7.Slide Two Way Top Plate (17) onto the Guide Rods (5).
8.Insert two Guide Rod Holders (50) into the Top Guide
Rod Retainer (7) Slide Top Guide Rod Retainer (7)
onto the top of the Guide Rods (5). Attach the Top
Guide Rod Retainer (7) and the
Connect Plate (23) (do not attach
Connect Plate (23) if you purchased
the optional Lat Attachment) to the
Upright (3) using two 3/8" X 3-1/8"
Hex Bolts (61), four 3/8" Washers
(74), and two 3/8" Nuts (77).
Insert two 50mm Plugs (48) into
each end of the Top Guide Rod
Retainer (7).
