STEP 4
LEG PRESS CABLE (243)
bolt end
metal ball end
-8-
Pull out the selector pin at weight stack of K1 gym to allow Top Cable movable.
1. Screw the threaded end (approximately half way) of the Leg Press Cable (243)
into the Base Frame (1) as shown in Fig. 1.
2. Then route the cable up to the lower pulley in the Adjustable Pulley Block (244) as
shown in Fig. 2. Mount the pulley using one 3/8" X 1-3/4" Bolt (233) and one 3/8"
Nut (241).
3. Continue to route the cable down to the pulley on the Base Frame (1) as shown in
Fig. 3. Mount the pulley using one 3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241).
4. Attach the pulley to the second hole from bottom. The multiple holes are for cable
adjustment. When cabling is complete, this pulley can be moved upward to take
up slack, or downward to gain length.
5. Continue to route the cable underneath the weight stack and around the
horizontally mounted pulley on the Leg Press Main Frame (202). Mount the pulley
using one 3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241) as shown in Fig. 4.
6. Continue to route the cable through the slot in Leg Press Main Frame (202), and
under and around (exiting on the top) the lowest pulley on the Rear Leg Press
Support (208) as shown in Fig. 5,7. Mount the pulley using one 3/8" X 1-3/4" Bolt
(233) and one 3/8" Nut (241).
7. Then route the cable under and around (exiting on the top) the right side (as if
sitting on seat) pulley mounted in Leg Press Main Frame (202) as shown in Fig.
6,8. Mount two pulleys here using one 3/8" X 2-3/4" Hex Bolt (232) and one 3/8"
Nylon Nuts (241).
8. Route the cable in the same manner under and around the uppermost pulley
mounted on the Rear Leg Press Support (208) as shown Step 1. Mount the pulley
using one 3/8" X 1-3/4" Bolt (233) and one 3/8" Nut (241).
9. Route the cable in the same manner under and around the left side (as if sitting on
seat) pulley mounted in Leg Press Main Frame (202) as shown in Step 2.
10. Hook the ball end of the cable into the receptor on the Rear Leg Press Support
(208) as shown in Fig. 9.
Hint: When viewed from the side, the Leg Press Cable should be a series of
"loops". There should not be any "X's".
