Owner’s Manual
25
VIII. MAINTENANCE
CLEANING
Remove dust on the treadmill with vacuum or slightly damp cloth. Fold up the deck and
cleaning the floor with vacuum periodically will help to prolong the treadmill product life.
NEVER use solvents on the deck or running belt. The use of solvents can reduce critical
lubrication of the deck and belt.
RUNNING BELT CENTERING ADJUSTMENT
When you run or walk, you may push off harder with one foot than the other. This will
cause the running belt to run off centered. This treadmill is designed and built to ensure
proper tracking of the belt is always centered on the deck. Occasionally the belt may
need further adjustment to keep it centered. To center the belt, use the enclosed Allen
wrench to adjust the rear roller position.
BELT CENTERING PROCEDURE
1.
DO NOT wear loose clothing, neckties or loose jewelry while making this
adjustment.
2.
NEVER turn the bolt more than 1/4 turn at a time.
3.
Always tighten one side and loosen the other to prevent over tightening or over
loosening the belt.
4.
Run the treadmill. Adjust belt while the treadmill is running at 4 Mi/H (6.4 Km/H) with
no person on the belt.
After making the adjustment, walk on the belt for five minutes to test. If necessary, repeat
the procedure but never turn the bolts more than 1/4 turn at a time. Over tightening the
belt can significantly shorten the belt life.
IF BELT TOO FAR TO THE LEFT SIDE:
1.
Turn the left roller bolt 1/4 turn clockwise (tighten)
2.
Turn the right roller bolt 1/4 turn counterclockwise (loosen)
IF BELT TOO FAR TO THE RIGHT SIDE:
1. Turn the right roller bolt 1/4 turn clockwise (tighten)
2. Turn the left roller bolt 1/4 turn counterclockwise (loosen)
DANGER!
To reduce the risk of
electrical shock, always
unplug the treadmill
from the electrical outlet
immediately after use
and before cleaning.
