Owner’s Manual
27
IX. TROUBLE SHOOTING
WHEN TO CALL FOR HELP
This treadmill is designed with user safety as the number one priority. In the event of
electrical failure, the treadmill will shut off automatically to prevent user injury and to
prevent damage to expensive components such as the motor.
When you encounter unusual behavior from the treadmill, simply go to the front of the
treadmill and turn the power switch off and on to reset the treadmill. This should clear
incidental errors and ready the treadmill for normal operation again.
If you have reset the treadmill by turning the power switch off and on again, and the
treadmill is still not operational, then it is time to call your dealer for service.
NO SIGNAL ON THE CONSOLE LCD WINDOWS
If there is no signal on the console, even if you turn off and turn on many times to reset
the treadmill, check the communication cable between console and motor controller.
First, make sure the connections are good and that the cable is not pinched or damaged.
If defective, ask your dealer for a replacement cable.
TROUBLE SHOOTING GUIDE
Problem
Potential cause
Corrections
Treadmill will not start
1.
Not plugged in
2.
Safety tether key not
inserted
3.
House circuit breaker
tripped
4.
Treadmill circuit
breaker tripped
5.
Switch on OFF
1.
Plug into grounded
outlet.
2.
Insert safety tether key
into console.
3.
Reset or replace fuse.
4.
Lubricate treadmill
deck and reset.
5.
Turn switch to ON
Running belt slips
1.
Running belt not tight
enough
2.
Drive belt not tight
enough
1.
Adjust running belt
tension
2.
Adjust drive belt
tension
Running belt hesitates when
stepped on
1.
Insufficient lubrication
2.
Running belt too tight
1.
Apply silicone lubricant
2.
Adjust running belt
tension
Running belt is off centered
Running belt tension not
even across the rear roller
Center the running belt
