26
Lubricant Application
1. Clean the deck surface and the inside part of the belt with a dry piece of fabric.
Clean the belt first by using a long piece of fabric across the belt and start the belt so
it makes two complete turns. Then, release the tension on the rear roller to be able
to clean the deck surface of any debris.
2. Open the lubricant supplied by your dealer. Place the lubricant tube in the middle
of the belt at about 15 inches from the hood cover. Step on the treadmill and step
down with your feet where the lubricant tube is located under the belt to make sure
that most of the lubricant is now spread evenly on the deck surface. DO NOT START
THE TREADMILL YET.
3. Remove the LUBE TUBE from under the belt and put the tension back again on the
rear roller. Stand where you applied the lubricant and press JUSTGO
TM
to start the
belt turning at 0.5 MPH (or 0.8 KMH). Let the belt bring you a the back of the tread-
mill and come back where you were standing. Do this twice so the lubricant will be
present on the total surface of the deck. Start the treadmill and get the speed up to
2 m/h or 3.2 km/h to make sure the belt alignment is correct. Refer to the owner’s
manual if any problem occurs.
BEST ZONE
Quick Troubleshooting Check List
If you experience a problem during the normal operation of the T280P–T280C–T300, use the following troubleshooting table below. If you
are unfamiliar or uncertain with basic diagnostic maintenance procedures, contact your Authorized Bodyguard
®
Dealer for diagnostics or
repair of your T280P–T280C–T300.
Table 3
PROBLEM
POSSIBLE CAUSE / SOLUTION
• Computer will not light
up when power
is turned ON.
• Unit is not plugged in. – Plug unit in.
• Power cord. – Check that power cord is functional; replace if necessary.
• Circuit breaker. – Reset the breaker.
• Damaged motor circuit board. – Contact your Bodyguard
®
Dealer.
• The wires are not connected. – Remove the cover and connect the wires properly.
• Belt doesn’t turn.
• Magnetic key is not in place. – Insert the magnetic key.
• Elevation does not
respond properly.
• It is not calibrated. – Perform Elevation Calibration.
• The wire is not connected on the motor circuit board. –
Connect the elevation wire to the circuit board.
• Motor drive does not
respond properly.
• It is not calibrated. – Perform Motor Check.
• The wire is not connected on the motor circuit board. –
Motor wiring harness needs to be connected to the lower board.
• Motor turns backwards.
• The wires are reversed on the circuit drive. –
Contact your Bodyguard
®
Dealer.
• Computer key(s) not
responding to touch,
or sticking.
• Keypad may be damaged by liquid penetrating through the seal. –
Contact your Bodyguard
®
Dealer.
• Excessive amount of cleaning solution used. –
Use mild cleanser on damp cloth only when cleaning console and unit.
• Squeaking noise from
the motor.
• Poly V-belt slipping. – Contact your Bodyguard
®
Dealer.
• Motor brush noise excessive. – Contact your Bodyguard
®
Dealer.
• Belt tracks left
and right.
• Uneven floor. – Move the treadmill to an even floor.
• Rear roller not adjusted for sloped floor. –
The rear roller needs to be adjusted. Perform Belt Alignment.
• Speed is not constant or
seems too fast or slow.
• The drive motor is not calibrated. – Perform Motor Check.
• The tension on the motor drive is too excessive. –
Remove tension on the running belt. Perform Belt Alignment.
• Can’t get out at the end
of a program.
• Elevation is not calibrated. – Perform Elevation Calibration.
• Error log
• See table 4
