6. You can modify the heart rate level suggested by the computer or press the JustGo
TM
/ENTER key to accept it and start
the exercise.
7. To start the exercise, press the JustGo
TM
/ENTER key.
During the Heart Rate Control or Weight Loss program, you can change the speed or elevation by pressing the Speed or
Elevation INCREASE or DECREASE keys. Keep in mind that the computer will then gradually readjust the speed and/or
elevation to compensate for the change in speed or elevation you made by gradually bringing your ACTUAL heart rate near
the TARGET heart rate level.
WARNING
– If you feel that the running belt is moving too fast for your fitness level and you cannot keep up, press the
CLEAR/STOP key and terminate the exercise program. You can try the program again, but at a lower INTENSITY level
(60%). If this is still too fast for you, do not use the Heart Rate Control program until your fitness level allows you to
safely exercise at your TARGET heart rate level.
During the exercise, the main computer screen will show a speed or elevation profile like the other programs, but will display
your ACTUAL heart rate and your TARGET heart rate on the message center. Once the exercise has started, your ACTUAL
heart rate should be lower than the TARGET heart rate. The computer then will gradually regulate the speed and elevation
simultaneously to increase your exercise intensity level, resulting in a higher ACTUAL heart rate.
Your heart rate will be displayed on the message center as ACTUAL heart rate and TARGET heart rate (T). For example:
HRATE 110/115T.
NOTE
– You can change your target heart rate while in the program by pressing the JustGo
TM
/ENTER key and modify it by
using the Speed DECREASE or INCREASE keys and by pressing the JustGo
TM
/ENTER key to accept it.
Walk Program
The Walk program allows you to create your own exercise as you progress in the program. The speed and elevation are
completely controlled by the user at all times. At a glance, Manual and Walk programs seem very similar due to the fact that
the user controls both the speed and elevation at all times. The difference is that in the Walk program, you can’t go over
4.0 MPH (6.4 KM/H) and 6% of elevation.
During the exercise, the speed and elevation that you select will remain for the entire exercise until the next change you
make. Your progression in the exercise is shown by the flashing dot.
Hill Climb Program
The Hill Climb program provides both a programmed hill
and speed profiles. The programmed hill profile will cause
the running belt to elevate and descend at various points
during your exercise. The programmed speed profile will
cause the speed to change. You can change the speed and
elevation during the exercise if you find it too easy or hard.
The speed and elevation will change as you progress into
the program. Changing the speed manually will cause only
that segment to change. Changing the elevation manually
will cause the entire elevation profile to change.
The following table shows the different elevations for each level.
Level
Speed (mph)
Speed (km/h)
Elevation (%)
1
2.0
3.2
0.0 to 3.0
2
2.0
3.2
1.0 to 4.0
3
2.0
3.2
2.0 to 6.0
4
2.0
3.2
3.0 to 7.5
5
2.0
3.2
4.0 to 9.5
19
SELECT
2
SPEED
DISTANCE
ELEVATION
ELAPSED TIME
TARGET REMAINING
PACE
CALORIES
CAL / HOUR
HEART RATE
3
figure 7
Summary of Contents for T360
Page 35: ...35 MADE IN CANADA ...
Page 36: ...Notes 36 ...
