5
The Device Controls
Attaching the Lead Wires
SLIDE COVER
A cover conceals the controls for Mode, Time, Width, and Rate. Press the front of the
cover and pull down in order to open the cover.
AMPLITUDE CONTROLS
The Amplitude Control knobs are located on the top of the unit. The Amplitude Control
knobs function as ON/OFF controls and adjust the intensity of the stimulation.
MODE
The Mode switch is used to select and set the type of treatment utilized. The three modes
available are: Burst (B); Continuous (C); and Modulation (M).
TIME
Treatment time can be set with the Time switch. There are two programs of fixed
duration for 30- and 60-minutes and one program of continuous output. Press the Time
switch until the desired position is engaged.
WIDTH
The Width dial regulates the width of the pulse for both channels.
RATE
The Rate dial regulates the number of pulses per second for both channels.
Insert the lead wires into the output receptacle located on top of the unit by holding the
insulated portion of the connector and pushing the plug end of the wire into one of the jacks.
After connecting the wires to the unit, attach each wire to an electrode. Lead wires provided
with the device are compliant with mandatory compliance standards as set forth by the FDA.
Note: Use caution when you plug and unplug the wires. Pulling on the lead wire instead of
the insulated connector may cause wire breakage.
Caution: Never insert the plug of the lead wire into an AC power supply socket.
