31
To use these electrodes:
1) Attach the electrode to the lead wire.
2) Remove the protective backing from the electrode surface. Do
not throw away the protective backing because it can be reused
after the treatment session has been completed.
3) Place the tacky surface to the prescribed skin area by pressing
the electrode firmly to the skin.
To remove your electrodes:
1) Lift the corner of the electrode and gently remove it from the
skin.
2) Apply the protective backing to the tacky side of the electrode.
Place the electrode on the side of the protective backing that is
labeled with the word.
3) It may be helpful to improve repeated application by spreading
a few drops of cold water over the adhesive and turn the
surface up to air dry. Excessive water will reduce the adhesive
properties.
4) Between use, put the electrodes in the re-sealable bag and store
them in a cool and dry place.
Caution
1) Do not pull the electrode wire. Doing so may damage the wire
and electrode.
2) Do not apply to broken skin.
3) The electrodes should be discarded when they lose
adhesiveness.
4) The electrodes are intended for single patient use only.
5) If irritation occurs, discontinue use and consult your physician.
6) Read the instructions for use of self-adhesive electrodes before
application.
