13
12
Chapter 14: OPERATING INSTRUCTIONS
1. Slide-on Cover:
A slide-on panel cover covers the controls for
selecting mode and adjusting settings. Your
medical professional may wish to set these
controls for you and request that you leave the
cover in place.
2. Power On/Off Switch and Intensity Controls:
If both controls are in the off-position, the device is switched off.
By turning the controls clockwise, the appropriate channel is
switched on and the indicator of power (CH1 or CH2) will reveal
on the LCD.
The current strength of the impulses transmitted to the electrodes
increases further when the control is turned clockwise.
To reduce the current strength or switch the device off, turn the
control counter clockwise to the required setting or off-position,
respectively.
The controls are protected by a cap to avoid unintentional change
of intensity.
3. Lead Connector
Connection of the electrodes is made with the two-lead
connector (lead wires). The device must be switched off before
connecting the lead wire. Both intensity controls must be at the
Off position. Electrodes must be pressed firmly on the skin.
4. Mode Control
There are 8 programs of option from P1 to P8. Press this bottom to
select a program desired.
5. Timer
The treatment time can be selected by pressing the “Timer” control.
There are five settings available: 15, 30, 60 minutes and continue.
Press the “Timer” control to select a.
6. Low Battery Indicator
A low battery indicator will show up when
the battery is low. Replace battery when the stimulation can not
be felt.
