BodyPerfect JFIRE, Owner'S Manual

- 6 - 

5. ASSEMBLY STEPS

Two persons are required to finish the assembly 

steps. 

(Caution!! Please follow exactly the assembly 

steps below to avoid injury.) 

1.

Tighten the lower Control Wire of Frame 

(B) with the Guide Thread attached in 

Right Upright (D) , then pull it into the 

Upright and clip the control wire with Wire 

Clip, then insert it into the Upright as the 

direction the round picture shows in the 

right drawing. 

2.

After finished the above steps, put the Left 

and Right Upright (C, D) on Frame and 

tighten with Hex Screw (a), Washer (b) as 

the right drawing shows. 

Ps.1. To avoid danger, always assemble the 

treadmill with more than two workers, do 

not assemble by yourself. 

Ps.2. When assembling the upright, make sure 

one person holds the upright to avoid 

falling. 

3.

After tightened the left and right handrails, 

pull the control wire out of the Upright and 

put the Computer Console above the 

Upright. Then connect the control wire of 

Frame with corresponding wire of 

Computer console (A). After that, tighten 

with Hex Screw (c) as the right drawing 

shows. 

Ps.1. To avoid danger, always assemble the 

treadmill with more than two workers, do 

not assemble by yourself. 

Ps.2. While fastening screws, make sure that the 

control wire of the tube isn’t damaged. 

C

D

A

c

c