- 6 -
5.
ASSEMBLY STEPS
Two persons are required to finish the
assembly steps.
(Caution!! Please follow the assemly
procedure below to aviod injury . )
1.
Attach the control wire-lower section
from the frame (B) to the guide thread
from the right Upright (D), then pull
the control wire into the Upright , clip it
with protecting ring and fasten it inside
of the Upright. (As shown in the circle of
the picture.)
2.
After finished above steps, put the right
and left Upright (C
、
D) on the Frame.
Secure with Hex Screw (a), Washer (b).
(As shown in the picture)
Ps.1. To avoid unexpected accidents,
assemble the treadmill with one or two
assistants.
Ps.2. During assembling the Uprights, one
person is needed to hold the Uprights
to avoid falling.
3.
After the Uprights are tightened, pull out
the Control Wires which have been
threaded into the Upright to the month of
the Uprights. Put the Computer Console
above the Uprights then connect the
control wire of the Frame with the
control wire of Computer Console (A).
After connecting, tighten them with Hex
Screw (c) shown in right drawing.
Ps.
1. To avoid unexpected accident, always
assemble the treadmill with an
assistant, do not assemble by oneself.
Ps.2. When tighten the screws, make sure not
to damage the control wires in the tube.
A
C
D
c
c