MAINTENANCE
1. If the belt tends to move off the centre, stop the
treadmill. Take the L-shaped Wrench and adjust the
Hex Screw in the Rear End Cap. For example, if the
running belt is moving towards the left side, tighten
the left Hex Screw about 1/4 turn (clockwise); if the
running belt is moving towards the right side, tighten
the right Hex Screw about 1/4 turn (clockwise). Turn
on the treadmill after it has been adjusted. If you find
that the belt has not moved to the proper position,
please repeat the steps above. Don't use the
treadmill until the running belts returns to the centre
position.
(
P.S.1.
This procedure is very important, if the belt is
not in the centre, be sure to follow the above steps.)
(
P.S.2.
The position of the running belt might not stay
precisely in the centre with slightly towards the left
and right sides, and the situation varies with how
end-users use this product. There is no need to
adjust the belt if it does not rub against the parts
inside.)
2. Depending on the usage of the product please
apply
SILICON
on the board according to the chart
located on the next page. Use the L-shaped Wrench
to unscrew the bolt inside the Rear Roller. Then pull
the belt up and daub some SILICON to the centre of
the board. After that, adjust the belt to the centre of
the deck followed by tightening the screw to the
original set.
(P.S. When the belt is sliding, please follow the
above method to lubricate the running belt.)
10
