- 10 -
8.
COMPUTER OPERATION INSTRUCTIONS
I. Start Display
:
1.
If the SAFETY KEY is taken off, the matrix window will display arrow adown. If the SAFETY
KEY is replaced
，
the matrix window will display KGS (LBS) for avoirdupois unit. Weight window
glitters and displays the pre-set value. The value is 70KG(150LBS) and range
23~130KG(50~286LBS). At this time the
light of Weight window shows. Finish setting or not
setting, press ENTER and the window will turn to Start / Ready status. The matrix window displays
pulsatile heart-shaped picture. The aim of setting weight is to make a change of burning
CALORIES. This can be only done after starting. It does not need to set in PROGRAM. It means
you can use the value after starting. You must set newly after starting again.
2.
If the SAFETY KEY is removed during work out, the beeper will sound and then the treadmill will
stop running. At this time place the SAFETY KEY back and all the values will go back to the initial
position.
3.
Under the common Start / Ready status, PULSE window will display HP picture if you don’t grip the
pulse sensor. If you grip the pulse sensor, you will see PULSE window starting to display pulse
value.
II. Operation Instruction
：
1.
：
Under Start/Ready position, you can press Mode directly to enter the program edit.
2. Under Start/Ready position, press Start to enter directly the start-up of Manu run.
3. If the machine has fan function, you can press
to start or stop fan. Pressing once means starting
and pressing twice means stopping.
** When the SAFETY KEY is taken off and then replaced, it will not make reposition action any where
it is. You need to press start key to perform the incline to reposite it.
** When power on, it will not make reposition action any where it is. You need to press start key to
perform the incline to reposite it.
** Under start/ready status, continuously press stop key for 5 seconds, it will make reposition action any
where it is.
** During perform any program, if press stop key, the program will stop. If users want to continuously
perform the program, press start key or again press stop key to leave the program and back to
start/ready status
