11
does not need to set in PROGRAM. It means you can use the value after starting. You must set
newly after starting again.
2.
During working, the beeper will make a sound for warning if the safety key works off, then the treadmill
will stop working. At this moment, put the safety key back to the recess of console, and all the values will
turn back to the initial values.
3.
If you don’t hold the Hand Pulse Sensor in general Start/Ready position, the
PULSE
window will
display HP. You will see the Pulse window display the heart pulse rates when you hold the Heart Pulse
Sensors on the handrails.
II.
Operation Instruction：
1.
Under Start/Ready position, you can press ENTER directly to enter the program edit.
2.
Under Start/Ready position, press
Quick / Start
to enter directly by pressing Manu run.
Press START and
after count down for 3 seconds (3
Æ
2
Æ
1), turn on the machine.
3.
The incline function of this system accords with correlative safety criterion. So it is only under
following instances to use incline function to automatically perform orientation action:
3.1
During operation, press STOP KEY and the system will enter PAUSE status and the motor will
stop. Incline motor will go back to origin automatically.
3.2 When the preset program or target is finished or the time arrives the max, the system will enter
RUN END status.
The main motor will stop and incline motor will go back to origin automatically.
3.3 Under Start/Ready position, if the incline is not at the origin, press STOP and after 5 seconds, it
will automatically come back to the origin.
3.4 Under Start/Ready position, if the incline is not at the origin, press START, the incline will
automatically come back to the origin.
4.
During reposition, press STOP KEY to stop it.
5.
During the workout, you can still press the
or
key to easily
adjust your desire incline or running speed. Or you can also try using
key to
change those functions at anytime.
III.
Edit Mode：
1.
Under Start/Ready position, press ENTER, press Program
to select Program mode.
2.
Program mode: During exit, if directly press Quick / Start to start
and then those which have not
been edited will adopt the preset values. During edit, INCLINE and SPEED windows will all
display first values and the matrix window will display this picture.
3.
WARM UP and COOL DOWN function: During WARM UP or Program position, change speed or
inclination, the value will increase or decrease in the next level. COOL DOWN is not affected and
