12
STOP is the only function which can be carried out.
4.
PROGRAM has 32 levels in all.
The three anterior are
WARM UP，
the three later are
COOL
DOWN.
Everyone is 3 minutes. The setting time except anterior and later which mean 6 minutes
will be execute averagely by surplus 26 levels.
5.
9 HOLES mode have not functions of WARM UP
or
COOL DOWN
. When distance is equal to
3.5KM
, the motor will stop and displays
” End”
.
IV.
Program Operation and Instruction：
MANUAL Mode
1.
When press Start key, it will count down at the first 3 seconds, after that, motor will start, and
the speed will start from the minimum value of the machine, the matrix window will travel
anticlockwise as the way of running on the playground, and each cycle is 0.4KM(0.25MIL).
2.
The speed STEP is 0.1 and press increase/decrease speed keys to select (the step is 0.1）
or press instant keys1、2、4、6、8、10 to select.
3.
The incline STEP is 1 and press increase/decrease incline keys to select（the step is 1） or
press instant keys 2、4、6、8、10、12 to select.
4.
TIME set or not set:
(1) When TIME has bee set, the window will display a time value counting down from the target
value, when the time reaches 0:00, the treadmill will stop automatically.
(2) When TIME hasn’t been set, the window will display the exercise time, when the time reaches
99:00, the treadmill will stop automatically.
5.
Press Stop when the motor is working, the motor will stop and the incline motor will go back to the
origin, the matrix window will display PAUSE; If you press
Start
again, the motor will start after
3-seconds countdown , the speed will be keep at the same before stop , and the incline will be
increased to the set height before stop .
6.
Under pause mode, press Stop / Reset and hold it for 3 seconds, it will come back to
start/ready status.
7.
It will go back to the Start/Ready position after 30 seconds in the Run End position (or press
Stop /
Reset
key).
8.
The time pre-set value is 0, range 20~99, when the time is edited at 20 minutes , you can press
to increase or decrease, the increase step is 1, if decrease , it will go back to 0 directly. During
exercise, the matrix window goes contrarotate like along playground. When carrying out, the center
of LCD matrix window will display the circle values.
V.
Program Mode
P1 Goal
1.
Under Start/Ready position, press
ENTER to enter P1 control mode.
2.
After entered, press ENTER TIME and the window will blink. At this time, users can press
ENTER to select TIME, DIS or CAL to set. After select the function, press ENTER to enter
