11
Step 5
Slide the seat support bracket (9) onto the aluminum rail (14). Secure using the quick release knob
(20) into your desired position. Connect the coil wire (50) to the back pulse wire (52).
Fix two bumpers (32)on each side of aluminum rail (14). Secure using two allen bolts (31).
Note:To aviod the noise between the quick release knob and the aluminum rail,
please make sure the quick release knob were loosen enough when you doing the rower
exercise.
Attach the right and left end caps (56L / 56R) onto the end of the aluminum rail (14).
Connect the upper extension pulse wire (44) to the upper pulse wire (49).
Connect the lower computer wire (45) to the upper computer wire (47).
Connect the lower rower sensor wire (46) to the upper rower sensor wire (48).
Attach the monitor (10) to the bracket of front post of the main frame (1). Secure using two screws
(38) which are found on the monitor.
Plug the adapter (103) into the adapter jack.
Note:
Ensure that the wires are safely tucked inside the opening so that the wires do not get
pinched when inserting the monitor onto the monitor bracket.
CHECK ALL BOLTS AND NUTS ARE TIGHTENE
BEFORE USING THE MACHINE
