Bodyworx L7750, Owner'S Manual

-11-

---

CABLE ASSEMBLY

--- 

1.

START WITH WEIGHT STACK CABLE 1440MM (23) 

START ATTACH CABLE (23) WITH M12 BOLT AND WASHER (47) TO WEIGHT 

STACK FASTEN THE OTHER END UP AND OVER AROUND PULLEY 

NO.1

, DOWN 

WITH CHAIN HOOK (36) AND CHAIN (27) AS SHOWN. 

2.

START WITH THE TOP LAT BAR CABLE 3250MM (24) 

START BY THREADING THE END OF THE CABLE THE SMALL BALL OVER GET 

INTO PULLEY NO.

2

, INTO OVER PULLEY NO.

3

, DOWN AND AROUND PULLEY 

NO.

4

 IN FLOATING PULLEY LOCK, UP AND OVER PULLEY NO.

5

 AS SHOWN. 

3.

CONNECT THE PEC DEC CABLE 2760MM (25) 

TAKE PEC DEC CABLE ONE END TO PEC DEC ARM AS PICTURED IN PEC DEC 

ASSEMBLY, USING M10*30MM HEX BOLT (59), M10 NUT (65), M10 WASHER (72) 

AND M10 NYLON NUT (68) TO SECURE CABLE TO ASSEMBLY, THEN THREAD 

THE OTHER END OF CABLE OVER PULLEY NO.

6,

 DOWN AND AROUND PULLEY 

NO.

7,

 IN PEC DEC PULLEY BLOCK (22) UP AND OVER PULLEY NO.

8

, USING 

M10*30MM HEX BOLT (59), M10 NUT (65), M10 WASHER (72) AND M10 NYLON 

NUT (68) TO SECURE CABLE TO ASSEMBLY.   

4.

START THE BOTTOM CURL BAR CABLE 3750MM (26) 

START BY THREADING THE END OF THE CABLE WITHOUT THE BALL UNDER 

PULLEY NO.

9

, UNDER PULLEY NO.

10

, UP AND AROUND PULLEY NO.

11

, IN 

FLOATING PULLEY BLOCK, DOWN AND UNDER PULLEY NO.

12

, UP AND 

AROUND PULLEY NO.

13,

 IN FLOATING PULLEY LOCK, DOWN AND AROUND 

PULLEY NO.

14, 

UP AND WITH CHAIN HOOK (36) TO CHAIN (27) TO TIGHTEN. 

NOTE: 

IF YOU FIND THAT THE CABLES ARE NOT LONG ENOUGH, USE THE 

EXERCISE CHAIN AS AN EXTENSION WITH CHAIN HOOK AS 

CONNECTORS. 

INSTALL WEIGHT COVER (76) TO TOP CROSS BEAM (10) AND LEFT BASE (03). 

SECURE USING M8*15MM BOLTS (64), M8 WASHER (73) AS SHOWN. 

ATTACH HAND GRIP (35) TO LAT BAR (30) AND CURL BAR (31).     

※

WARNING: MAAKE SURE ALL CABLES DO NOT RUN OUT OF TRACK