Installation
To install the Audio Power Amplifier:
1.
Ensure the POWER switch is in the off position.
2.
Connect the universal mains power line cord into the
amplifier.
3.
Connect a Cat5 type cable into the amplifier’s Ethernet port
and ensure the other end of the cable is correctly connected
to your network.
4.
Set the Amplifier Mode switch to the desired setting.
This amplifier can be configured for single-channel bridged
mode (aka bridged-tied load) operation for 70V/25V/8Ω
applications, or 2-channel (mono) operation for 25V/8Ω/4Ω
applications. The Amplifier Mode switch is used in
conjunction with the Bridged Signal routing setting in the
system console.
1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430
1-800-999-2809
© Copyright 2018, Bogen Communications, Inc.
5
WARNING:
The apparatus shall be connected to a mains socket
outlet with
a protective earthing connection.
To reduce the risk of fire or electric shock, do not ex
-
pose this apparatus to rain or moisture.
The apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
Where the mains plug or an appliance coupler is used
as the disconnect device, the disconnect device shall
remain readily
operable.
