Failure to observe minimum speaker impedance will cause
the amplifier to self protect until the speaker configuration
is corrected.
6.
If using Line Input, route the input.
The amplifier uses a balanced line level (up to 2V RMS) ana
-
log audio input. You can use either XLR or Phoenix (but not
both) as the input.
This input can be routed to either or both amplifier channels,
depending on the setting of the Amplifier Mode switch.
7.
Plug the power line cord into the power source.
8.
Toggle the Power switch to the On position.
9.
For information about configuring the amplifier for the
Nyquist system, refer to the
Nyquist Audio Power Amplifiers
Configuration Manual
.
Power Ratings
The NQ-A2300 can provide 300 Watts into two separate chan
-
nels into 25V, 8Ω, or 4Ω, or 600 Watts Bridged (one channel) into
70V, 25V, or 8Ω load configurations.
1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430
1-800-999-2809
© Copyright 2018, Bogen Communications, Inc.
8