9
3.3
Zone Paging
You can choose to page only certain areas of the facility, called zones.
The zones, which are collections of stations, must be created through
the Web-based System Admin User Interface (UI) before zone paging
from the VoIP Phone can occur. Zones appear in the phone’s Direc-
tory under the Paging menu. The Paging menu also includes entries
for Facility Paging when applicable.
To make a zone page:
Step 1
Select the soft key labeled
Directory
.
Step 2
Use the navigation keys to select
Paging
and then
press
OK
.
Step 3
Use the navigation keys to select
Zone Page
and then
press
OK
.
Step 4
When prompted enter the zone number and press #.
Step 5
Talk into the handset, or if using the speakerphone or
headset, talk into the microphone.
Step 6
Hang up when finished.
3.4
Record Page
You can record a page to be added to a zone queue. The maximum
length time for a recorded page is 60 minutes; if the recording
exceeds 60 minutes, it will time out and not be saved. If the recording
is silent for 60 seconds, it will time out and not be saved.
Pages in a zone’s queue are played in the order that they are placed
in the queue. A live page started on a zone that is playing a recorded
page will cause the recorded page to be terminated and sent back to
the queue. The interrupted message will play again from the begin-
ning of the message when the zone becomes idle. Multi-Site Emer-
gency-All-Call, Multi-Site All-Call, Emergency All-Call, All-Call, Alarm,
Tone, and Emergency Announcement will also interrupt any queued
messages playing in any zones. All re-queued messages will play
Note:
When the DTMF Code #{Zone Number} is used to initiate a
zone page, Nyquist will start recording a queued page if the zone
belongs to a queue. If you want to start a real-time page to the
zone instead, dial #{Zone Number}*.
