12
6
Playing Tones
Nyquist provides tones that can be used with events, such as bell
schedules or announcements. In addition to the default tones, tones
can also be created or downloaded through the Admin Web UI.
To play a tone:
Step 1
Select the soft key labeled
Directory
.
Step 2
Use the navigation keys to select
Tones
and then press
OK
.
Step 3
Use the navigation keys to select the tone that you
want and then press
OK.
Step 4
To end the tone, hang up.
7
Forwarding Calls
If your VoIP Phone has the appropriate CoS parameter set, you can
forward your calls to another Nyquist extension, whether it’s a physi-
cal station or a Web UI station. You can select to always forward calls,
forward calls if you are on another call, or forward calls if they are not
answered within a specified number of seconds.
The DAHDI FXS based Admin Station (also known as Analog Phone
station Type) does not display an incoming call queue, and there is
no incoming call queue prioritization. If the DAHDI FXS based Admin
Station is already on a call, subsequent VoIP call-switch callers will
continue to ring as expected. However, there is no visibility that an
incoming call is happening, and there is no FIFO queue to handle
multiple incoming calls.
If a VoIP phone directly calls a DAHDI FXS Admin Station that is busy,
the call will go to voicemail.
For incoming emergency calls from an Analog Call Switch and
Speaker or Digital Call Switch and Speaker station types, if the DAHDI
Note:
The
Directory/Tones
submenu is only available on Nyquist
E7000 and only if the station
Type
is set to
Admin Phone
.
Note:
If you want to end a tone started by another VoIP Phone or
Admin Web UI, use the navigation keys to select
Stop Tone
.
