OPERATING INSTRUCTIONS
1.
Plug the appliance in
2.
Pour the appropriate amount of water into the warmer base (G) using the measuring cup (E, see paragraph GUIDELINES)
3.
Insert the bottle and jar holder (A) in the warmer base (G)
4.
Insert the bottle in the holder (A); if you are using a standard/small bottle, place the adaptor ring (D) around the bottle to
obtain a better heating result
5.
When heating a jar of baby food, remove the lid and insert the jar in the holder (A)
6.
Press the ON button to activate the appliance. The LCD starts twinkling, and shows “01: 30” as standard operating time. You
can define an operating time between 1 and 12 minutes by pressing the buttons on the left (higher) and right (lower) side of
the ON button. Press the ON button again to start the heating cycle after you have set the desired operating time. The LCD
turns bright blue when the appliance starts working.
CAUTION!
The steam that comes out of the appliance during the heating cycle is very hot. During operation, touch only the
control panel (C).
7.
During the heating cycle, the operating time on the LCD display counts down from the time you have set. When the heating
cycle is finished, there will be three “beeping” sounds to remind you that the heating cycle has finished. The appliance will
then switch off automatically.
Remarks:
1.
During the heating cycle, you can press the ON button to pause the operation or to adjust the operating time. Press the ON
button again to restart the heating cycle. The appliance will switch off automatically if you do not restart it within 5 minutes
after it has been paused.
2.
There will be rapid “beeping” sounds to warn you if the water in the warmer base runs out, and the thermostat will switch
off. The heating cycle will continue after you refill the water in the warmer base. The appliance will switch off automatically if
you have not refilled the water within 1 minute after the warning signal.
3.
While the device is operating, you can stop the operation by pressing the ON button for 2 seconds. Press the ON button
again to reactivate the appliance after you have made the necessary adjustments.
GUIDELINES
Please note that these are indicative values. The required heating time may vary depending on the ambient temperature,
start temperature of the contents of the bottle or jar and temperature of the water in the warmer base.
Quantity of water in bottle
Start temperature
Type of bottle
Home ml
Home Time
Car ml
Car Time
60 ml
20°C
Large plastic bottle
9 ml
1:00
8 ml
4:00
90 ml
20°C
Large plastic bottle
9 ml
1:10
7 ml
4:00
120 ml
20°C
Large plastic bottle
11 ml
1:15
8 ml
4:00
180 ml
20°C
Large plastic bottle
9 ml
1:20
8 ml
4:00
210 ml
20°C
Large plastic bottle
10 ml
1:30
9 ml
4:00
240 ml
20°C
Large plastic bottle
8 ml
1:30
9 ml
4:00
330 ml
20°C
Large plastic bottle
15 ml
2:30
10 ml
6:00
60 ml
4°C
Large plastic bottle
9 ml
1:30
8 ml
4:30
90 ml
4°C
Large plastic bottle
9 ml
2:00
9 ml
5:30
120 ml
4°C
Large plastic bottle
10 ml
2:00
10 ml
7:00
180 ml
4°C
Large plastic bottle
12 ml
2:30
10 ml
7:30
210 ml
4°C
Large plastic bottle
13 ml
3:00
10 ml
8:00
240 ml
4°C
Large plastic bottle
17 ml
3:20
11 ml
9:00
4
