S2000R
25
www.bolid.ru
To assign polling loop addresses to a group of the radio link devices, select the required devices in
Device Area, right-click the selection to open the drop-down menu and select Auto Addressing. Then
specify an initial address and an increment (1 by default) in the opened window “Group Addressing”.
For the radio link devices which have several inputs / outputs the required number of addresses is
allocated automatically.
SETTING RADIO LINK DEVICE PROPERTIES
Individual settings of radio link devices depending on the device type are available on the
Device Properties tab in Data and Control Area:
–
S2000R-SMK:
•
Enabling Monitored Circuit (On / Off).
–
S2000R-ASR2:
•
Low pulse rate input / high pulse rate input;
•
Selecting the meter output type (dry contact / NAMUR);
•
Selecting frequency mode;
•
Controlling the Water Leak Sensor input (On / Off).
–
S2000R-IP and S2000R-DIP:
•
Enabling tamper alarms;
–
S2000R-RM:
•
Selecting the power supply or the battery as a “main” power supply;
–
S2000R-IK, S2000R-IK rev.02, and S2000R-SHIK:
•
Operating the test mode;
–
S2000R-IK rev.02:
•
Selecting the detection precision.
Option menu can be open by left-clicking on the field with pencil icon (see Figure 7-6).
The address of the ARR32 within the polling loop can be assigned only individually.
While assigning addresses for multi-zone devices manually please pay attention to the
assigned values in order to avoid duplication. Refer to the PL Address string for the
previously connected radio device on the Device Properties tab in Data and Control
Area.
