Section 3: Common quick setting and operation
The host
s power cords are red, black and yellow, red and black wires connect directly to the vehicle battery
or go through vehicle fuse, the red wire links to the positive, while black wire links to the negative, yellow wire links
to firing wire ACC (the position before vehicle to start the motor). However, if under other testing environment
without vehicle, following wiring method is needed: twist red and yellow wires to link to the positive, black wire links
alone to the negative, then you can use the switch power supply above DC12V-5A to supply power to the host.
1:When power is supplied after correct wiring, the PWR blue light on the panel will keep on, standby
2:Connect the output wire AV-OUT to display and connect other according devices to the host, make sure the
connection is correct.
3:Need to turn off electronic lock with a key to the LOCK position (required) is the normal starting up,
the corresponding light turns yellow after starting up.
Below Figure 4-1 is testing wiring, as well as the the power supply wiring during actual loading.
Only used as a test wiring
Car circuit
control
Red line
Black line
Yellow line
Car battery
-
1
The power supply voltage input range is DC8-36V, when there is only a blue light on, it is
a standby state which is not really starting up; more than one light will be on under normal
start up status.
2
The host can not be delayed shutdown when you use testing wires for the power supply of host.
Need to use input method when input text, such as the company name, license plate number, driver's name, line
number, and other text input needs when requires input method under other menu. Take inputting
Yue B95886
for example after entered the input interface to illustrate the input steps
Step One: in the state of Chinese input, as shown in Figure 4-2, Character YUE(GuangDong)
s Pinyin is YUE,
move the cursor to press ENTER key to input the first Chinese letter y, it will display the corresponding PinYin
combination 1-5, if there is no PinYin as YUE, please press the FWD key on the remote control to the next pages;
when it shows 1.you 2.yu 3.yuan 4.yue 5.yun on the next page, please press the number 4 on the remote control
which will show 1-5pcs of Chinese characters, if there is no YUE character, please use FWD button to turn the
pages; when it shows 1 read 2 key 3 Yue 4 Guangdong Yue, please press 4 to input the first Chinese character
YUE(GuangDong).
Step Two: Now you will need to input the letter B, move the
cursor to pressENTER key to switch the input method
to the state of capital letters, as Figure 4-3, then move the cursor onto the letter B to press ENTER key to input it.
Step Three: Next you will need to enter numbers, press it again to switch to Chinese input state, you can not input
numbers under Chinese input state, then you need to move the cursor to the "in (middle)" word, press ENTER key
to turn to EN, and then enter numbers 95886.
After the completion of above steps, press the RETURN key to go back and save, other text input under other
menus will be more or less the same. Please press CANCEL to delete it when there is a typo during the input process.
Connection diagram
Note
