Page 2 of 2
Manual Handheld Reader
On/off
Press the “ON/OFF” button. The unit will switch off automatically after 1 minute if a
sensor is not connected.
‘ur’
If you connect a sensor, but no - or less than 10% - load is applied, the reader will show
‘ur’. This means ‘under load’ and indicates that there is a connection with the sensor,
but at less than 10% of its maximum. Apply more load and values will appear.
Toggle units
Press the “UNITS” button to toggle between readings in “kN” or in “lbf”.
Store the read value
Press the “STORE” button while the sensor value is shown on the display. Up to 256
readings can be stored in the instrument. Only the last reading on each sensor is
stored, i.e. one reading per sensor and no history of readings.
Upload the stored values to a PC
This function requires the BS-Report Generator program to be installed on the PC.
The sensor data is uploaded to the PC by connecting the SM-200 to the PC’s USB port.
Press the “STORE” and “ON/OFF” buttons simultaneously to put the SM- 200 into the
“r232” mode. Start the “BS-Report Generator” program and click the “SM- 200” button.
Follow the instructions on the screen, and the sensor data is transferred to the PC.
Clear the memory
By pressing “UNITS” and “ON/OFF” simultaneously, the display will show “clear”. To
clear the memory, press the “STORE” button.
Reading PMS sensors
The BoltSafe PMS probe is needed for reading BoltSafe PMS sensors. This probe
energizes the BoltSafe sensor and reads back all data by means of a non-contacting
interface. The probe is connected to the SM-200 with a connector.
Change battery
To change the battery, open the rear lid using a screwdriver (4 screws). The battery is a
9V Alkaline (6LR61).
Instructions for use
Phone
Website
