17
Coolant
Coolant
Coolant
Coolant
WAR
WAR
WAR
WARNING
NING
NING
NING::::
The coolant circuit of this appliance contains the
refrigerant Isobutane (R600a), a natural gas that is
flammable and of high environmental compatibility.
Make sure no parts of the coolant circuit get dam-
aged during transport and installation of the appli-
ance.
If the coolant circuit is damaged:
If the coolant circuit is damaged:
If the coolant circuit is damaged:
If the coolant circuit is damaged:
•
avoid any open flames or ignition source,
•
disconnect the plug,
•
thoroughly air the room in which the appliance is
installed and
•
contact an authorized technician.
Transport
Transport
Transport
Transport and Packaging
and Packaging
and Packaging
and Packaging
Transport the appliance
Transport the appliance
Transport the appliance
Transport the appliance
Transport the appliance, if possible, only in vertical
position. Otherwise, it is absolutely necessary to
allow the appliance standing upright for a few hours
before installation ”Prior to first use”. Protect the ap-
pliance during transport against weather influences.
NOTE
NOTE
NOTE
NOTE::::
The appliance has castors which facilitate the
transport and installation of the appliance. Tilt the
appliance back slightly and move it gently.
Unpack the appliance
Unpack the appliance
Unpack the appliance
Unpack the appliance
•
Remove the appliance from its packaging.
•
Remove all packaging material, such as foils, filler
and cardboard packaging.
•
To prevent hazards, check the appliance for any
transport damage.
•
In case of damage, do not put the appliance into
operation. Contact your distributor.
CAUTION: Transport protection!
CAUTION: Transport protection!
CAUTION: Transport protection!
CAUTION: Transport protection!
Pull off the foil from the appliance sides.
NOTE
NOTE
NOTE
NOTE::::
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter “Cleaning”.
Appliance
Appliance
Appliance
Appliance Equipment
Equipment
Equipment
Equipment
Appliance overview
Appliance overview
Appliance overview
Appliance overview
1111
Control panel /
Temperature control
2222
Compartment with
freezing flap
3333
Freezing drawers
4444
Adjustable feet at the front /
castors at the rear
Delivery sc
Delivery sc
Delivery sc
Delivery scope
ope
ope
ope
1 x freezing flap, 5 x freezing drawer, 1 x ice-cube
tray, for assembling the door handle: door handle
incl. fixing screws with covers, for reversing the door
opening: dummy cap (A)
Installation
Installation
Installation
Installation
Condition
Condition
Condition
Conditions for the installation location
s for the installation location
s for the installation location
s for the installation location
•
Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
-
Gap to the back and to the side walls each
approx. 5 cm;
-
Place the appliance so that the appliance door
can open without being impeded.
•
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter “Technical Data” or to the rating label
located in the interior or on the rear side of the
appliance.
