29
Repairs
Repairs
Repairs
Repairs
A wrong or improperly performed repair brings danger to the user.
Repairs to electrical appliances must only be carried out by an authorized specialist. A damaged pow-
er cord must be changed only by a qualified electrician.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
Before you contact an authorized specialist
The following problems can be solved by you by checking for the possible cause.
Problem
Problem
Problem
Problem
Possible cause
Possible cause
Possible cause
Possible cause
Solution
Solution
Solution
Solution
The appliance is
not working
properly or at all.
-
Is the unit not connected to mains
power?
-
Is the temperature setting correct?
-
Is the place unqualified?
-
Does the content prevent the appliance
door from closing properly?
-
Are the ventilation openings clear of
obstruction?
-
Insert the plug properly in the contact
socket. Check the fuse.
-
Check the temperature setting.
-
Check the ambient temperature.
-
Check the appliance content.
-
Unblock the ventilation openings, install
the appliance freely.
The content is
not cold enough.
-
Is the temperature setting correct?
-
Was the appliance door open for an
extended period?
-
Was large quantity of food placed in
the appliance within the last 24 hours?
-
Check the temperature setting.
-
Open the door only as long as necessary.
-
Adjust a colder temperature.
The content is
not cold enough
-
Is the appliance near a heat source?
-
Check the installation location (see “In-
stallation”).
Loud noise dur-
ing operation.
Is the appliance not leveled vertically and
horizontally?
Adjust the feet accordingly. Liquid flow
sounds in the cooling circuit are normal.
Water on the
bottom.
-
Is the temperature setting correct?
-
Is the water discharge opening
blocked?
-
Check the temperature setting.
-
Check the discharge opening.
Interior light
does not work.
-
Is the unit not connected to mains
power?
-
Is the light bulb defect?
-
Insert the plug properly in the contact
socket. Check the fuse.
-
See the section “Interior light”.
The housing
becomes warm-
ly.
The refrigeration cycle takes place in the foaming. The heat exchangers are installed in
the housing covered. The appliance cut the interior heat, which must be dissipated
through the housing areas.
Water on the
outer surface.
On days of high humidity, condensation might occur on the outer surface of the appli-
ance. This is no malfunction; you may simply wipe the water off.
