27
Tips for Energy saving
•
Disconnect the appliance from the power supply if
it isn’t in use.
•
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
•
Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
•
Place all shelves, racks or drawers (depending on
the model) in their original position.
•
Adjust the temperature not colder than necessary.
•
Allow warm food to cool before placing it in the
appliance.
•
Open the appliance door only as necessary.
•
Defrost the unit regularly (model dependent).
•
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning and Maintenance
WARNING:
•
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
•
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
•
The unit must be dry before restarting operation.
CAUTION:
•
Do not use a wire brush or other sharp, abrasive
items.
•
Do not use any acidic or abrasive detergents.
•
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
To keep dirt and germs at bay, clean the appliance
regularly!
•
First clear out the contents of the appliance and
store it in a cool place. Remove all moving parts
such as shelves or drawers.
•
Clean the interior of the appliance, the exterior
surfaces and the accessories with lukewarm wa-
ter and a mild cleaning agent; or with a clean,
damp microfiber cloth without cleaning agent.
•
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
•
After everything has dried thoroughly, you can put
the appliance back into operation.
•
Depending on the model:
At least once a year,
wipe off the dust that has accumulated on the rear
wall of the unit and on the condenser (metal
grille). Use a soft brush or a vacuum cleaner for
this purpose.
Cleaning / replacing the door seal
Regularly check the seal for dirt, damage and air
tightness!
Checking the seal for air tightness
•
Clamp a thin piece of paper at various points for
testing. The paper must be equally difficult to pull
through at all points.
Cleaning the gasket
•
Clean the gasket with clear water only!
•
CAUTION, grease and oil makes the seal porous
and brittle. Wipe up grease or oil immediately with
a damp, clean cloth.
Replacing the seal
•
Remove the contents of the appliance and, if
necessary, defrost the unit. Pay attention to how
the old gasket is attached. Most gaskets are only
plugged in.
Summary of Contents for KG 322.1
Page 30: ...30 ...
Page 31: ...31 ...
Page 32: ...32 C Bomann GmbH www bomann germany de Made in P R C Stand 10 2022 ...
