17
Setting MIN
Setting MIN
Setting MIN
Setting MIN
Setting NORMAL
Setting NORMAL
Setting NORMAL
Setting NORMAL
Setting
Setting
Setting
Setting MAX
MAX
MAX
MAX
lowest setting
(warmest in-
side temp.)
middle setting
(optimal operating
temperature)
highest set-
ting (coldest
inside temp.)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
Interior light
Interior light
Interior light
Interior light
The indoor light is switched on or off via the on/off
switch.
Storing
Storing
Storing
Storing
The appliance is exclusively suitable for cooling and
storing drinks.
Several storage levels for inserting the grid shelves,
allows individual storage. Note the maximum loading
of each shelf is 35 kg.
Store large bottles horizontally, with the opening
facing forward on the grid shelves.
Operating noise
Operating noise
Operating noise
Operating noise
Type of sound
Type of sound
Type of sound
Type of sound
Cause
Cause
Cause
Cause
Mumbling
Compressor during its operation
Liquid sounds
Circulation of the refrigerant
Click sounds
The temperature control turns the
compressor on or off
Disturbing
noises
Vibration of the shelves or cooling
coils
Switching
Switching
Switching
Switching off
off
off
off
To switch off
To switch off
To switch off
To switch off the appliance
the appliance
the appliance
the appliance disconnect it from the
disconnect it from the
disconnect it from the
disconnect it from the
power supply
power supply
power supply
power supply
If the appliance is out of use for long periods:
•
Remove the appliance content.
•
Clean the appliance thoroughly (see ”Cleaning
and Maintenance”).
•
Leave open the appliance door to prevent un-
pleasant odours.
Tips for Energy saving
Tips for Energy saving
Tips for Energy saving
Tips for Energy saving
•
Disconnect the appliance from the power supply,
if it isn’t in use.
•
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
•
Ensure sufficient ventilation at the bottom and
rear side. Never block ventilation openings.
•
Do not adjust the temperature colder than neces-
sary.
•
Do not leave open the door for longer than re-
quired.
•
The appliance should be defrosted regularly, if
necessary.
•
Switch on the indoor light only if necessary.
•
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
