GB
32
•
Short-time operating:
use the device for no longer than
2
minutes with soft foods
and no longer than
1
minute with hard foods. Leave the device to cool down for at least
3
minutes before using again.
•
Caution:
The blade of the bar mixer is very sharp! It should therefore be handled with
extreme caution! DANGER OF INJURY!
• The appliance is designed to process only small quantities of food! Fill the container
with the maximum quantities specifi ed in the table!
• Do not put hard foods such as ice cubes, nutmeg or large pieces of chocolate into the
container! The blade can be damaged!
Scope of supply:
1 bar mixer with integrated blade
1 mixing vessel with lid (0.7 litres)
Suspension
eye
Before Use
• Take out all the parts carefully out of the packing. Save the packing and the inner
packing material for the whole duration of the warranty.
• Clean the device before using it for the fi rst time as described in „Cleaning and Mainte-
nance“. Caution: The blade of the bar mixer is very sharp!
Danger of injury!
Using the Device
1. Place the hand-held mixer on the motor housing. Now turn the mixer until the
쑽
/
쒀
marks are aligned with one another.
2. Fill the food to be mixed into the mixing bowl (max. 0.7 litres). Immerse the mixing bar
fully, but only up to the MAX mark.
3. Please hold the device in such a way that you can operate pushbutton
I
or pushbutton
II
with your fi ngers.
Pushbutton I
:
This switches on the minimum speed and cannot be regulated.
Pushbutton II
:
This provides the maximum speed and cannot be regulated.
4. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
5. Press one of the buttons.
6.
Pulsed mode
is switched on by pressing the appropriate pushbutton at intervals and
then releasing it again.
7. The device switches itself off when the button is released.
8. To release the bar mixer please turn it in the opposite direction.
9. Pull out the plug from the socket after use. Clean and put the device away as described
in „Cleaning and Maintenance“.
10.
Note:
Attach the cover under the base so that the shaker is stable.
05-SM 1916 CB 32
14.07.2006, 9:24:51 Uhr