Operator's Manual
Rev. BXXMP.01 January 2020
The steering column is not centered with the seat, it is displaced
75 mm to the left, so the operator's arm (left) has a relaxed
position when driving the steering wheel.
For a correct regulation, we recommend to put an angle such
the operator does not have to move the left shoulder when his
left arm is in top of the steering wheel.
REAR VIEW MIRRORS ADJUSTMENT
Both exterior mirrors can be adjusted, so the operator has a
clear rear view from both sides.
It is very important to check both mirrors regulation every time
the operator uses the machine, in order to prevent accidents
when driving backwards.
JOYSTICKS DASHBOARD ADJUSTMENT
The frame where the 2 hydraulic joysticks are installed can be
adjusted in angle respect the right arm.
You have to loosen both handles, and them adjust the joysticks
frame. Once the position is good, tighten both handles gently.
STARTING THE ENGINE
For the low temperature starting, see paragraph
Low
Temperature Starting
.
- Engage the parking brake.
- Put the forward/reverse speed selection rocker to neutral.
- To start the engine, turn the ignition switch to
HEAT
, for at least
3-4 seconds. If the outside temperature is very low, you can
maintain the pre-heaters for up to 10 seconds. A yellow light will
glow on the column instrument.
- Step on the accelerator pedal.
- The turn the key to
START
, and once the engine is started,
release the accelerator pedal, and release the key so it goes to
ON
position.
If the engine does not start within 20 seconds, release the key
and wait at least 2 minutes before attempting again.
- After the start-up, let the engine run at idle for some minutes
before engaging a gear; this allows for a gradual warm up of the
21/34
BOMAQ INDUSTRIES SLU
MODEL BXX MP
