••
IF
THE BUOYANCY TUBE WAS STORED AT A TEMPERATURE BELOW
GOC
132°F,
LEAVE
IT
AT 2GoC
168°F
FOR 12 HOURS BEFORE UNFOLDING.
1.
Check the
Aerotec
air floor fitting inside the boat (to facilitate fitting, you can slightly inflate the
main buoyancy tube).
2.
Inflate the air floor to correct pressure
3.
Finish inflation of the tube to correct pressure
4,
Tighten the buckles.
We recommend that you leave the
Aerotecfloor
in
the boat when folding.
However, to clean perfectly the boat it may be useful to take off the
Aerotec
floor:
1.
DISMANTLE:
Deflate the boat
Take off the
Aerotec
floor (reverse the installation procedure).
2.
MAINTENANCE:
inflate again the boat
Wash off with clear water, then raise the boat's nose to evacuate water and sand or rubbish.
