ENGINE
Oil Change and Oil
Strainer Cleaning
Oil is to be replaced and oil strainer
cleaned at the same time. Oil change
should be done with a warm engine.
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
vmo2006-014-035_a
LH SIDE UNDERNEATH CVT COVER
1. Oil drain plug
Unscrew the oil strainer cover.
Allow enough time for oil to flow out
of oil strainer hole.
vmo2006-014-036_a
RH SIDE OF ENGINE
1. Oil strainer cover
Remove oil strainer and spring.
To clean oil strainer, use a solvent then
dry with compressed air.
WARNING
Always wear eye protector. Chem-
icals can cause a rash break out
and an injury to your eyes.
NOTE:
Check cover O-ring and replace
it if necessary.
Wipe out any oil spillage on engine.
vmo2006-014-037_a
1. Cover
2. O-ring
3. Spring
4. Strainer
Reinstall oil strainer, spring, O-ring and
torque cover to 15 N•m (133 lbf•
in
).
Verify drain plug washer condition and
replace it if necessary.
_____________________
103
Summary of Contents for DS 250
