OPERATING INSTRUCTIONS
General
Transmission lever must be on NEU-
TRAL to allow engine starting.
To start engine, place the engine stop
switch to RUN position, insert key in
ignition switch and turn to ON then
press start button.
NOTE:
For your convenience, an over-
ride mode allows the engine to be
started with the transmission lever in
any position. Press and hold the front
brake lever while pressing the start
button.
Pre-Operation Check
WARNING
The pre-operation check is very im-
portant prior to operating the vehi-
cle. Always check the proper op-
eration of critical controls, safety
features and mechanical compo-
nents before starting. If not done
as speci
fi
ed here, severe injury or
death might occur.
Before using this vehicle, the operator
should always:
• Apply parking brake and check if it
operates properly.
• Check tire pressure and condition.
• Check wheels and bearings for
wear and damage.
• Check location of controls and en-
sure they work properly.
• Verify if steering operates freely.
• Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
• Activate the brake levers and brake
pedal to make sure the brakes fully
apply. Levers and pedal must fully
return when released.
• Ensure transmission lever is work-
ing then reset in NEUTRAL position.
• Check drive chain for adjustment
and lubrication.
• Check sprockets for wear and dam-
ages.
• Check tightening of rear axle fasten-
ers.
• Check swing arm, if any lateral play
is detected
DO NOT USE THE VE-
HICLE
.
• Check fuel, oil and coolant levels.
• Check for oil leaks on the engine
and the transmission.
• Ensure fuel valve is in fully open
position (ON).
• Clean headlamps and taillight.
• Ensure seat is properly tightened.
• If you transport cargo, respect load
capacity. Ensure cargo is properly
secured to the racks.
• If you are pulling a trailer or other
equipment, ensure it respects the
tongue capacity and towing capac-
ity. Ensure trailer is properly se-
cured to hitch.
• Look and feel for loose parts while
engine is off. Check fasteners.
• Ensure the path of travel is free of
persons and obstacles.
• Check operation of ignition switch,
start button, engine stop switch
and headlamps.
• Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Bombardier ATV dealer as nec-
essary.
82
______________________
Summary of Contents for DS 250
