62
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
UNDER VEHICLE
1. Oil drain plug
Wait a while to allow oil to flow out of
oil filter.
Reinstall the rubber hose on engine.
Unscrew oil filter cover.
Remove the oil filter and replace by a
new.
NOTE:
Check and change the O-ring,
if necessary.
RH SIDE OF ENGINE
1. Oil filter cover
2. Oil filter
3. O-ring
Wipe out any oil spillage on engine.
Change gasket on drain plug. Clean
gasket area on engine and drain plug
then reinstall plug. Refill oil tank at the
proper level with the recommended
oil. Refer to SPECIFICATIONS for ca-
pacity.
Start engine and let idle for a few min-
utes.
Check if the RED indicator lamp stay
ON, if yes, stop engine and bleed sys-
tem by removing oil filter and bleeding
screw.
BEHIND OIL FILTER
1. Bleeding screw
Ensure oil filter area, hose and drain
plug areas are not leaking.
Stop engine and check oil level. Refill
as necessary.
Dispose oil as per your local environ-
mental regulations.
Other Components
CAUTION:
Do not lubricate throttle
and clutch cables.
V02C03Y
1
V02C04Y
2
1
3
V02C05Y
1
vmo2000_001b.fm Page 62 Friday, September 17, 1999 1:21 PM
