Bona Capricorn Manual
16
Machine Adjustment Procedures
Adjusting sanding pressure
Before sanding check drum operation on the work surface.
OK: Drum and wheels are parallel to the surface to be sanded
and the mark left by the drum is the total roller length.
Turn the adjustment knob (A)
clockwise to decrease drum
pressure on the floor.
1.
2.
Turn the adjustment knob (A)
counter-clockwise to increase
drum pressure on the floor
To vary drum pressure on the floor, use the adjustment knob and proceed as follows:
Wheel adjustment
The diagram shows the two possible cases:
NO: The drum does not rest fully on the surface and only
sands at one part, emphasizing marking on the floor.
If the drum operation is like in "NO" diagram, the drum and wheels must be positioned parallel to the surface to
be sanded by varying the height of complete wheel holder.
Loosen the locking nut (A).
1.
2.
Turn the screw (B) clockwise to raise the end of the side drum
cover off the floor. Turn the screw (B) counter-clockwise to
lower the end of the side drum cover towards the floor.
3.
Once the desired position
has been reached, secure the
locking (B).
In order to adjust it proceed as follows:
