Bona Capricorn Manual
17
EN
Wall edge castor
A support with a free castor has been fitted to avoid damage to the skirting board or wall when sanding
along the wall.
Abrasive Assembly Procedure
Machine Adjustment Procedures (Cont.)
The wall edge castor is correctly positioned when the machine is approximately 8 mm
away from the wall with the castor up against it.
Before starting work, position the castor correctly by loosening the
bolt (A), moving the support to the required position and tightening
the bolt (A).
Using a damaged abrasive which could then tear while sanding may damage the
machine or floor.
Do not start the machine without the abrasive inserted, otherwise the drum will be damaged and
must be replaced. The abrasive is in the correct position when it protrudes approximately 1.5 mm
from the sander drum. Using a damaged abrasive may cause damage to the machine or floor.
Fit the abrasive to the drum ensuring that the abrasive protrudes
approximately 1.5 mm from the drum itself.
Routine Maintenance
To keep the machine in good working condition the following items
must be checked and serviced regularly.
Sawdust chamber (for the user)
Vacuum the sawdust chamber
regularly.
Drum (for the user)
Check the outer surface of the
drum regularly. Remove any dirt.
Wheels (for the user)
Remove dirt from the machine
unit and wheels regularly. Dirt
may cause uneven sanding.
