EN
Bona Edge UX
15
Machine Adjustment Procedures (Cont.)
The tilt of working plate is determined by the position of the
wheels on their support. This support slides on a guide and can
be set at the needed position by a locking knob.
Follow the
‘Replacing
the cogged belt’
(pag.16) up to point 3.
1.
1.
For moving upward/downward the machine loosen the lower
knob. Turn clockwise/counter-clockwise the screw using the
upper knob. Screw again the lower knob to lock the wheel
position.
The wall protection is replaceable in easy
way by unscrewing the two fixing screws
from the two slots, that allow to adjust in
opportune way its distance from the wall.
2.
2.
Adjusting the working surface on the floor
Wall protection
To keep the machine in good working condition the following
items must be checked and serviced regularly (every 250
working hours or at least once a year).
All maintenance must be done on neutral machine!
Always disconnected the machine from power supply before
it is cleaned, tools are changed, maintenance is performed or
when worn parts are replaced.
Routine Maintenance
