Multi-Appliance Slimline Control
Introduction
Bonaire Control Systems
Page 5
Introduction
GENERAL INFORMATION
I
MPORTANT
I
NSTALLATION
N
OTICE
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed in
accordance with the installation instructions and the governing body regulations, Climate Technologies
reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
NOTE:
Only a licensed person will have insurance protecting their workmanship.
M
ODEL AND
S
ERIAL
N
UMBER
Your appliance model number, serial number and model description are located on the appliance data plate
on the end of the heater or inside the cooler in the vicinity of the electronic controls. These details should
also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
W
ARRANTY
Warranty service work must only be carried out by Climate Technologies service division or its authorised
service providers. See warranty section.
A
SSEMBLY
There is no assembly required of these Ducted Heating or Cooling products. Your Dealer or installer will
carry out all assembly and commissioning upon installation.
L
IMITATIONS
The Slimline Controller is only to be used with MB 3, 4 & 5 star Heater Control and Evaporative Cooler
Control.
The Slimline Controller will only control:
a)
One Ducted Central Heater
b)
One Evaporative Cooler
c)
A combination of one Evaporative Cooler and one Ducted Central Heater.
If the Heater is connected to the R & W input, only Heat mode will be available. Fan mode will not be
available.
