1-866-771-2663 | Page 7
ASSEMBLY INSTRUCTIONS
1.
Flip the tank housing (D) upside down and
attach the wheel assembly (J) to the base of the
tank housing (D) using 2 M8 x 16 screws (CC).
3.
Attach the tank housing supporter (G) into the
tank housing (D) using 1 M8 x 16 screw (CC) and
2 M5 x 12 screws (AA). Do not fully tighten to
allow room for adjustment later in the assembly
process.
J
D
CC
22.
T
o add additional
ballast and weight to
the
base, open
the
door of the tank housing
(D).
Remove the plastic plug at the center of
the
base, then pour 7.5 kgs
of
sand
(appro
x
imately
3
/
4
of the cavity)
through the
hole at
the
center of the
base.
Once
sand is
placed,
fill the hole with
water until
water
reaches
the
top of the rim.
Insert
the
plug
into the hole
tightly;
Clean any additional
spilled
sand and water.
Sand
Water
