INCORRECT
TIPS:
Before Beginning
●
Read the instructions thoroughly.
●
For future reference, save this instruction sheet.
See WARNING and Figures :
WARNING
This screen must be clear and free of
obstructions at all times to insure proper
operation.
The burner of the fire table must be covered by
lava rocks completely. Otherwise the flame may
be extinguished occasionally. See the Figure
CORRECT and INCORRECT for reference.
CORRECT
Perform leak test in a
well-ventilated area outside and where no source of spark can occur.
Remove battery from igniter. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit to the ‘off’
position to pressurize the hose assembly. Use a soapy water solution to check all the connections leaks before
attempting to light the appliance.
If a leak is found, turn the tank valve off and do not use the appliance until
repairs can be made.
●
Check and make sure that all parts are present.
TO LIGHT
Before each use, inspect all hoses. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.
(2) Light the fire table as below steps:
LOW
HIGH
OFF
IGNITER-PUSH
7
Cover must be removed when burner is in operation.
Fire table and propane gas cylinder minimum distance must
be over 60'' (as per the right side photo).