BONEX-SCOOTER
Instruction for use
Version: 2016_08
Page 2
The scooter has double seals on all shaft openings and
housing seals.
To ensure that the seals seal perfectly, the seals must be
cleaned and greased regularly!
The scooter is supplied with a control voltage after switching
on the main switch. The scooter therefore consumes power
even when the scooter is not in use (approx. 3W).
Make sure that the main switch is turned to „OFF“ after use.
In case of longer transports we strong advise you to
disconnect the plug from the battery.
Failure to do so may lead to a total discharge of battery
over a prolonged time and this can cause irreparable
battery damage!
The scooter must be locked according to the instructions prior
to usage.
The scooter may only be operated closed and with the
silver eccentric locking lever in the folded locked
position!
Battery should not be thrown in the domestic waste but
disposed of separately!
Either return the used battery to the manufacturer (disposal is
free of charge) or take them along to a collection point for
used batteries.
The battery may not be exposed to direct sunlight.
Temperatures below freezing point should also be avoided
during storage.
Heating or very low temperatures reduce the service life
of the battery!
The battery should ideally be stored in a safe, dry place
between 15°C and 20°C.
If you will store the scooter for a prolonged time, keep
the battery partially charged, this will ensure a long
service life of battery!
Summary of Contents for BONEX-SCOOTER Series
