ver.2016 r1
IGNITOR
/
ELECTRODE
CHECK
With all control knobs set to “OFF”, check each igniter individually for presence of spark
at electrode. In turn, push each control knob in fully and turn slowly about a 1/4 turn to
the left (counter-clockwise) until a click is heard; the trigger hitting the strike block
should produce a blue spark at the electrode tip. Return control knob to “OFF” before
checking next igniter.
BURNER
OPERATION
CHECK
NOTE:
Upon first assembly the gas lines and burners will be full of air. In order for the
burners to light properly the lines must fill with gas. It may require several attempts at
lighting the burners before you are successful.
1. With BBQ Grill control knobs in “OFF” position, turn on the Gas supply.
2. Light any burner by pushing its control knob in fully and slowly (3 to 4 seconds)
turning it about 1/4 turn to the left (counter-clockwise) until a click is heard. The 3 to 4
second duration should provide enough gas to light the burner. If the burner does not
light, immediately return the control knob to “OFF”, wait several minutes for the gas
to disperse, and repeat the process. After burner lights successfully, turn control
knob to “OFF”.
3. Repeat process for each control knob/igniter, in turn, ensuring that other knobs are in
“OFF” position as you perform each check.
4. If any burners fail to light after several attempts, discontinue gas supply at source
and re-inspect for obstructions to gas flow and orifices.
Toll Free: (855) 678-0088
bonfireoutdoor.com
Page 26