5
4)
Insert the reel shaft into the solder wire
reel and set it to the reel holder at the
bottom.
Refer to the right photo.
Make sure that each diameter you set up
and the solder wire is the same.
※
Applicable solder wire diameter:
DIA. 0.3 ~ 0.8 mm
Remove the protection cover from the V-
blade with a Phillips screwdriver.
5)
Lead the solder wire to the wire guide
nozzle along the guide pulley.
Turn on the power switch and press the
foot switch. Check out that V-grooved
solder wire will come out of the nozzle
correctly.
※
Do not touch the V-blade when
working.
6)
After confirm that the solder wire has
been led correctly, stop pressing the foot
switch.
Rewind the solder wire reel in order to
take up the slack of solder wire.
Put the protection cover back in place.
V-cut machine is ready to work
.
Protection cover
