Page 13
3BE390843NU – 01/12
BONNET GRANDE CUISINE
Registered office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
1.7.6 FAULT DISPLAY
Error messages may appear when the unit is first switched on or after prolonged use.
♦
The red alarm light will stay on permanently if there is a fault.
♦
The green alarm code light will illuminate once for a long period then flash a number of times
repeatedly. The number of flashes corresponds to the error code number
♦
These temporary indications do not mean there is necessarily a problem with the unit and it may
continue to be used.
♦
If the unit fails to function inform the service technician of the message, conditions and frequency it
appeared.
Problem…
Possible causes
What to do?
The unit does not work the
display is blank
There is no electrical supply to the unit.
The supply or the connections are
faulty
Check the state of the electrical
installation.
Error code number:
1
The unit has not detected a pan.
The pan you are using is not suitable
for induction cooking
Put a pan on the heating area.
Use a suitable magnetic pan.
Check the inductor
Error code number:
2
No inductor, no power to the supply
side
Check the state of the electrical
installation. Connect the inductor
Error code number:
3
Ventilation ducting is blocked, fan is
dirty, probe has failed
Clear the air circuit, clean the fan.
Error code number:
4
Pan is empty or temperature probe
defective
Remove the pan, wait until the cooking
surface cools down.
Replace the probe.
Error code number:
5
Control unit is defective
Check / replace the control unit.
Error code number:
6
Ventilation ducting is blocked, fan is
dirty, temperature probe has failed
Clear the air circuit, clean the fan
Error code number:
7
The inductors temperature probe has
short circuited
Check / replace the probe.
Error code number:
8
An electrical phase is down
Check the phases
Error code number:
11
Hardware initialisation error
Control connected unnecessarily
Wait the unit reboots automatically every
30 seconds.
Connect the controls to an appropriate
switch
Error code number:
13
Indicates local under or over voltage
Check the connections to the mains
Error code number:
14
Indicates under or over voltage to the
unit
Check the connections to the mains.
Error code number:
15
Pan is empty or temperature probe
defective
Remove the pan, wait until the cooking
surface cools down.
Replace the probe if necessary, switch the
unit off for a few minutes then on again
NOTE: When first connecting the unit wait a few seconds before touching the control panel to allow the electronics to stabilise.
